ep

January 18, 2021

DUMP TRAILER Power UNIT-DOUBLE ACTING
Basic Description
This energy unit has a power up electrical power down circuit with load holding on the two A & B ports. A pressure compensatred flow control is often additional to circuit to manage the decent pace with the cylinder.
Particular Notes
one. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, 30 seconds on and 270 seconds off.
two. Clean each of the hydraulic parts concerned ahead of set up of the energy unit.
3. Viscosity on the hydraulic oil shoud be 15~46 cst, which ought to also be clean and free of impurities. N46 hydraulic oil is encouraged.
four. The electrical power unit really should be mounted horizontally.
five. Check the oil degree in the tank immediately after the first operating in the power unit.
6. Oil modifying is needed following the original one hundred operation hrs, afterwards the moment every single 3000 hrs.

DUMP TRAILER Energy UNIT- SINGLE ACTING
Standard Description
This electrical power unit has a electrical power up gravity down circuit. Begin the motor to extend the cylinder and activate the solenoid valve to retract the circuit. Manual override to solenoid valve could be presented if expected. Also a pressure compen sated flow manage is usually additional to the circuit to regulate the descent speed of the cylinder.
Remark: Please seek advice from our product sales engineer for your different pump displacement, motor electrical power or tank capability.
Distinctive Notes
1. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, thirty seconds on and 270 seconds off.
two. Clean all of the hydraulic parts concerned just before set up of the electrical power unit.
3. Viscosity of your hydraulic oil shoud be 15~46 cst,which must also be clean and no cost of impurities.N46 hydraulic oil is advised.
4. The power unit need to be mounted horizontally.
5. Check the oil level during the tank following the preliminary running of the electrical power unit.
six. Oil changing is required immediately after the initial one hundred operation hrs, afterwards after every single 3000 hours.