ep

January 20, 2021

Power UNITS FOR LIFT TABLE one
Basic Description
This power unit is developed solely for the little lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has been broadly employed during the field of logistic gadgets such as minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled through the solenoid valve with the pace controlled from the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Common Description
This electrical power unit is intended solely for that medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing motion is actived through the solenoid valve as well as pace controlled through the adjustable needle valve. Once the lift rises to a higher positoin, however the electrical power supply is minimize, the reducing motion is managed through the guide override function.
Energy UNITS FOR LIFT TABLE 3
General Description
This power unit is developed solely to the substantial lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering movement is actived by the solenoid valve as well as pace managed by a strain compensated movement handle valve.
Electrical power UNITS FOR LIFT TABLE four
Common Description
This electrical power unit is developed exclusively for that significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve and the pace managed from the adjustable needle valve. Once the lift rises to a large positoin, but the electrical power provide is cut, the decreasing motion is controlled by the manual override perform.
Distinctive Notes
one. This power unit is of S3 duty cycle, which can only operate intermittently and repeatedly, i.e. one minute on and 9 minutes off.
2. Clean all the hydraulic parts concerned in advance of installation of the energy unit.
3. Viscosity with the oil shoud be 15~46 cst,which really should also be clean and absolutely free of impurities.N46 hydraulic oil is encouraged.
four. Oil modifying is needed immediately after the initial one hundred operation hrs,afterwards the moment every single 3000 hrs.
five. The power unit proven is made to be mounted vertically.